Every minute a burst pipe runs, more water goes into your floors, walls, and slab. The single most useful thing you can do in a plumbing emergency is shut off the water at the main valve — and the time to learn where that valve is, is now, not while water is running across the kitchen floor.
Key takeaways
- Find the main shut-off before an emergency — slab homes hide it in specific spots.
- First step when a pipe bursts: shut the water off, then call.
- On a well, shut the pump off too; when leaving a lake house empty, shut the water off first.
Where the main shut-off is in a Spicewood home
Spicewood homes are almost all slab-on-grade, which means there is no basement and the main shut-off is usually in one of a few places. Check these in order:
- Where the water line enters the house. Usually on the wall facing the street or the well, often in a garage, utility closet, or laundry room. Look for a lever handle or a round wheel valve on the largest pipe coming through the wall.
- Near the water heater. The cold-water inlet valve on top of the heater shuts off water to the heater, not the house — but the main is often nearby.
- At the meter or well head. On a private well, the shut-off may be at the pressure tank or the well house. On a small water system, it may be at the meter box near the street. The meter shut-off needs a meter key, which is worth keeping in the garage.
- In the well house. Many Spicewood well houses have their own shut-off for the pump and the house line. If your home is on a well, find this valve before winter, not during it.
Once you find it, test it. A valve that has not moved in years can seize, and a seized valve in an emergency is no valve at all. Turn it off and on once a year, and if it sticks, have it replaced while the house is dry — not while it is flooding. Our leak detection and repair in Spicewood, Texas page covers what happens after the water is off.
What to do first when a pipe bursts
- Shut off the main valve. Turn a lever handle a quarter turn until it is across the pipe; turn a wheel valve clockwise until it stops.
- Turn off the water heater. Cut the power or gas so the heater does not fire while it is empty. Close the heater inlet valve as well.
- Open a tap at the lowest point in the house. This drains the lines and relieves pressure.
- Open taps upstairs too. They let air in so the lines drain instead of holding water.
- Move valuables and electronics away from the water. Then mop, towel, and get air moving — fans and open windows if the weather allows.
- Call a plumber. Describe where the water is coming from and what you have already shut off.
Do not touch any electrical outlet, switch, or appliance that is standing in water. If water is near the electrical panel, leave the house and call the utility. For urgent leaks, see our emergency plumbing services in Spicewood, Texas.
On a well: shut off the pump too
If your home is on a private well, shutting the main valve stops water leaving the house, but the pump can keep running against a closed valve if the burst is on the well side. Switch the pump off at its breaker or the pressure switch in the well house. A pump running dry or dead-headed against a closed valve can burn out — and a burned-out pump is a far bigger job than a burst pipe. See our well pump repair and installation in Spicewood, Texas page for the well-side boundaries, and our guide to well water problems in Spicewood for pressure problems.
Leaving a lake house empty? Shut the water off first
Many Spicewood lake houses sit empty for days or weeks between visits. A small leak that would be noticed in an hour at home can run for days in an empty house. Before you leave, shut off the main valve and open a tap to relieve pressure. In winter, that one step is the difference between a small repair and a house full of water. This is the single best habit a second-home owner can build, and it costs nothing.
Practice it once, with the whole household
Show everyone in the house where the main valve is and how it turns. Label it with a tag so a guest or a house-sitter can find it. Keep a meter key and a flashlight nearby if the shut-off is outside or in the well house. A five-minute walk-through now saves a frantic search later, when the floor is already wet.
We are Lake Travis Plumbing. If a pipe has burst or a valve will not turn, call (254) 822-6941, Monday to Friday, 9 AM to 5 PM, and tell us what you have already shut off. For freeze protection that stops bursts before they start, read our guide to preventing frozen pipes in Spicewood.
Frequently Asked Questions
Where is the main water shut-off in a Spicewood slab home?
Usually where the water line enters the house — a garage, utility closet, or laundry room — or at the meter, pressure tank, or well house. Look for a lever handle or wheel valve on the largest pipe entering the house.
What should I do first if a pipe bursts?
Shut off the main valve, turn off the water heater, open a low tap to drain the lines, move valuables away from the water, and call a plumber. Do not touch electrical outlets or switches standing in water.
How do I shut off the water if my home is on a well?
Shut the main valve, then switch the pump off at its breaker or the pressure switch in the well house, so the pump does not run against a closed valve and burn out.
Should I shut off the water when I leave my lake house empty?
Yes. Shut the main valve and open a tap to relieve pressure before you leave. A small leak in an empty house can run for days unnoticed.
What if the main shut-off valve will not turn?
Do not force it — a seized valve can snap. Use the meter shut-off if you have a meter key, and have the main valve replaced while the house is dry.
Get help with plumbing in Spicewood
If a pipe has burst or your shut-off valve will not turn, call Lake Travis Plumbing at (254) 822-6941 and tell us what you have already shut off.